How to Treat a Dust Mop Head

As long as there is  an adequate amount of
dust mop treatment in the head, it will
continue to pick dirt and dust from the floor
and "lock" the soil in.

Remember that treatment is constantly being transferred
from the mop head to the soil it has picked up.  To replace
lost treatment it is recommended that approximately one
ounce of treatment per foot of mophead be re-applied with a
trigger-type sprayer. Once treatment has been applied to the
yarn it begins to penetrate by a process called capillary 
action.  Depending on the yarn being used, absorption may
take anywhere from a few minutes to hours.  To be safe, six
to eight hours should be allocated for the process when using
an oil based treatment.  If using a pure water based treatment
such as our Dust Seeker water based treatment-just spray it on
and go to work-no time needs to be wasted between re-treating
and dust mopping.  In any case, treatment should be re-applied
to the dust mop head at least daily-providing a "ready" dust
mop for each shift.